Begun making use of aqualoon also in my filter. Filters fantastic, but indeed, backwashing doesn't function thoroughly. It's really a new filter, and only apparent h2o is popping out Once i do a backwash. I also open my filter and clean them by hand by rinsing them Using the hose.

For your wealth of pool treatment details please look into our free of charge Pool Faculty. Should you be in need of distinct assist then we persuade you to Sign up and inquire us in this article inside the Discussion board!

I've tried using the Potassium Peroxymonosulfate in a couple of tubs, but I don't Consider I am receiving the exact same end result I used to be with Sodium Monopersulfate.

We just acquired this property per month back and I believe the earlier fella experimented with but when he remaining me his exam package and it only did chlorine and PH I was just a little worried. I've a complete/full package. When I came Together with the pool inspector for inspections, he also experienced the chlorinator functioning at a hundred% and in the event the pool guy asked why, he just said that's what they established it at (new pool two.

Mdragger88 stated: For decontamination needs you are able to Allow the purge water sit overnight with slam fc level. Kinda like soaking a gross pot

Hello there , This thread is inactive for more than 60 days. New postings Here i will discuss unlikely being noticed or responded to by other customers. For better visibility, take into account poolvlies Beginning A whole new Thread.

I have been adhering to the TFP technique for many many years now and It truly is served me perfectly. Ideally this thread is often a start off on shelling out it ahead for the next person who runs into similar concerns.

Just moved right into a new home with a comparatively new (2.5yrs aged) salt drinking water pool. It is thoroughly automated by having an EasyTouch Manage Centre so I've been Discovering a good deal considering the fact that we've moved in (per month back).

Also make sure to have some sanitizer while in the h2o since you should contact the h2o to scrub (i would go slam degree) Click on to increase...

rjdoviak said: Planning to test the VS location first. Ran 3 days Together with the com port disconnected and no difficulties. Looks as if a comm incompatability. What had been the acknowledged comm difficulties that you talked about? Click on to grow...

Some makers of fuel heaters alert that cycling the heaters on and off once the drinking water is a lot less than 70°File could cause problems. Because of this, you ought to be aware that utilizing your heater to maintain pool h2o above freezing could cause problems.

If grime and oils are involved you must take out These 1st with a little something alkaline (think degreaser/surfactant (like your purge solution) then use acid for mineral scale.

muriatic acid or insert by body weight or by quantity of dry acid. Observe: pH calculations rely upon TA and Borate. Effects are approximate and will be off noticeably for giant pH improvements.

The main reason I'm submitting nowadays is to substantiate my suspicion that my Intellichlor IC40 requires replaced. It is gone into "Cold Water Cutoff" mode. Intellichlor manual states it must go into this method at 52 degrees +/- 3.